Dirty Rigger Glove Size Guide

A well-fitting work glove is a safer work glove.

Too big and the spare material can snag on kit, rigging or machinery; too small and the glove restricts your movement and becomes uncomfortable over a long day. This guide will help you find your Dirty Rigger size, and pick the right glove style for the job.

1Fingers together, lightly. Hold all four fingers together, but don't press them together firmly. This gives the most accurate measurement of the width of your hand.

2Measure below the knuckles. Place the tape just below your knuckles, wrap it around your hand and note the measurement.

3Find your size. Look up your measurement in the chart below. If you are between sizes, go for the larger size.

Full fingered

The classic work glove, covering the whole hand. A comfortable barrier for rigging, kit handling and manual work, with a fitted design that moves with your hand.

Framer

The thumb, index and middle fingertips are cut short, so you can tie off, work clamps and press buttons by feel while the rest of the hand stays covered.

Fingerless

All fingertips free for the most intricate tasks, while still keeping around 90% of the hand covered.

• Close, with no gaps. The glove should sit snugly at the fingertips and around the wrist. A snug fit minimises snagging; a glove that is too big is more likely to get caught.
• Not too tight. A glove that is too small hampers movement, can rub and cause friction burns, and can even restrict blood flow to your hands.
• Full movement. You should be able to stretch your fingers, make a fist and grip just as you would without gloves.